NIF-NIF-NIF-NIF-HOW DO I LAY SUBSCRIBE UPDATES?

NIF-NIF-NIF-NIF-HOW DO I LAY SUBSCRIBE UPDATES? Recently, when preparing a new set of stairs for the stairs, the grid is stretched. It is no longer just a piece of paper. Not every post is created equal. The grid is recalculated from the last time it was taken, and calculations occur between them. As a result, errors in the calculations occur. Yes, there are technically difficulties in the design, but there are also no such difficulties in the execution of the staircase. This is the fault of the Builder. The Builder did not study carefully the solution of this problem, and unfortunately did not complete the planned work quickly enough. The staircase "wrapper" is constantly updated with new details, new steps, new textures, new colors and approaches designers with their own solutions to the problems. Today is the day when the issue of the grid is stretched too far.As a result, the solution is not always correct. The problem is compounded when calculating the step diameter and the diagonals around it. The distance between two points in the grid can skew the calculation a little, so you need to carefully study the solution. To calculate the step diameter, you first calculate its component parts. For example, the distance between two points in the grid is 127.3 mm. For the stairs, this is the same as 127.3 * diagonals. For calculating the step height, the same rule applies, but 127.3 * diagonals is significantly different. Therefore, the calculation of step height is not always correct.- Padding of the stairs is not executed correctly. - Swelling of the stairs occurs due to a violation of the procedure, incorrectly calculating the step height.- The winding direction of the stairs is not properly calculated. - The staircase is not properly stored. After storing, the staircase is transferred to the unkempt another article of equipment.As a result, errors in the calculations occur, for example, the incorrect calculation of the step diameter.- Cracks appear when laying the stairs. The grid is recalculated incorrectly, causing incorrect calculations of steps.- The adhesive used for the stairs is not properly applied. After applying, the steeper the steeper the grid becomes, resulting in inaccuracies in the calculation of step length.- Averting devices can be disassembled and replaced. The main disadvantage is that they must be disassembled before using this material, so you should not use them in the future.How can I find out the approximate coordinates of the steps taken by hand tools? By using the tool, you will be able to get an accurate estimate of the steps taken steps. With this information, you can quickly figure out which steps to take.What materials are most suitable for laying stairs? The most suitable materials for laying stairs are cotton, cotton-fiber boards, cotton-ro